Colloidal Silver
For Your Protection from H5N1 &
all other pathogens. No harmful side effects.
Use only 99.999999999%
pure Silver
The silver should be in the form of bezzle, not wire. This is
because
of the need
for a greater surface area than is available with the
wire. Bezzle is like a "strapping",
a flat strip, like that used by
jewelers to hold a stone setting or cab onto a ring.
Right click on the diagram
and save the image to print it out.
- 2, -- 7 inch strips of
99.999999999%
PURE silver
- 3, -- 9 volt rectangular
batteries
- solder'
- flux
-
2 strips of "light-ish" weight wire, about 7 inches long and just
a bit heavier than that on the snap-on leads
- HOT soldering gun.
(They don't all heat
up to hot enough!)
solder all the red wires from the snap-on
leads to one 7 inch piece of wire
solder all the black wires to the other 7
inch piece fo wire
solder each of these to a strip of silver
Stand two batteries up side by side with poles turned as in above
diagram
Turn the third battery "upside down" and snap it, centered, onto the
other two
Snap on the leads to the remaining battery poles as shown in the
diagram.
One connection on each of the snap-on leads will not be snapped on to
anything.
Be sure to snap the lead that goes to the
black-wired solder joint to the (wide) negative battery pole, the
red-wired one to the positive (smaller) battery pole.
This is rather hard to describe in the usual "positive" and "negative"
battery pole frame of reference, so be careful to check yourself
closely with the diagram to be sure of getting it right. Once you
have the batteries set up this way, use some red nail polish and mark
the back of one of the snap-on connector pieces with a red "+" so that it
will be easy to see which one to
connect to the positive battery pole that is left open after
snapping the batteries together.
(a 27
volt transformer would be a BIG improvement over the batteries!)
Since
the 90's, when I used one of these devices continuously for a 6 month
period with no problem, the battery poles have begun to be made of
thinner, softer metal and do
not hold up for many snaps on and off before they loosen up and then no
longer provide the full 27 volts. This will make a "brown" silver
that
is NOT nano particulate and is not good to drink.
Of all the more recent batteries that I have used, the Radio Shack
brand have "kept their snap" better than others.
SETTING UP THE SILVER IN THE JAR
Put silver strips in quart jar filled with
purified water, without
letting the two strips touch each other.
(If they touch, it will immediately drain out the batteries)
Be sure that the solder joints do not touch the water
One strip should soon start to form little bubbles, the other should
start to send off a little fine stream of silver particles .
When making a batch, I put a folded black plastic garbage bag on the
countertop to provide a dark enough plain background to make the
bubbles from the one side, and the bit of silver streaming from the
other much more readily visible.
It can be hard to get the two
strips of silver to set up in the jar without touching each other.
You should work on this to get a good "feel for it" before hooking it
up to the batteries. I use a couple clothespins on the rim of the
jar to help anchor each one in place on opposite sides of the
jar. DO NOT clamp down ON the wires or solder joints
though! (this would cause them to heat up). There is a
metal spring in the clothespins that should not touch the wire, solder
joint or silver. I cover it with electrical tape, but this needs
to be done with care not to get it too tight to be able to squeeze the
clothespin open! When connecting to the batteries, the wires will
not hold still, so the connection needs to be made before placing the
silver into the jar of water. Be sure you have practiced enough
at getting the silver strips to set up without touching. Once you have
them set up, take them out and do it again a few times until you KNOW
how it 'behaves'. Putting a LITTLE-bit of bend in the strips to
get them to "conform" will help, but can't very well be
described, you just have to work it, like OJT, before "going live":-)
How & Why It
Works
Electrolyzing 99.99999% pure
silver (at 27 volts) for about 15 minutes per quart of water will kill
any single cell pathogen by destroying its ability to"breathe".
All viruses,
bacteria, mold, fungus- are single cell organisms which "breathe"
through a chemical exchange process and the nano-sized particles
obtained by electrolyzing silver this way are small enough to enter,
destroying the ability to make this chemical
exchange. These
particles are also small enough to penetrate every cell in the human
body. Attaining a systemic level of colloidal silver in the body
will protect a person from
these pathogens. These organisms cannot mutate around this to
adopt an immunity to the silver.
I do not know really, how much one needs to injest to attain a systemic
saturation level of silver, but, the sooner it starts, the
sooner one's soft machine will have the benefit of its immutably
protective live-scanning programming fully installed as needed in these
times when hackers abound, busily bio-engineering new mutational
definitions for breeching both natural and pharmaceutical defences. In
just the past few months there has been such an increase in the number
of people who are now using Colloidal Silver that it has been freed
from the improperly imposed classification to the fringe-world of the
far fetched "mysterious" where only fools and tin-foil hatters are seen
to tread. It is a relief to know that at least a good number will be
protected from the weaponized H5N1 and other heinously mass
manufactured lethalities our government has concocted to use
against us.
I would suggest giving yourself at least 8 oz. twice daily, though
perhaps with the propensity for things like H5N1 to get loose from the
labs, you should consider that more would not bring you any harm.
There is a "blue man" out there making a silly spectacle of himself,
but either he is a mole with blue dye, or he didn't cook his silver
proplerly and drank gobs of it in brown with little blobs. I tend
to think more along the lines of dye though since he has become only
blue in the face.
The Generously Spirited Dr. Robert (Bob)
C. Beck
Folks from the Vancouver
Amatuer Inventors and Gadgeteers show
how two Bob Beck devices can be put into a single board, and how it
works, with an oscilloscope. Might come in handy should the bird flu
H5N1 mutate into a human virus and a pandemic happens. Let's hope not!
The Bob Beck Protocol Pulser is a supposed health cure-device, perhaps
like Hulda Clark's. Need one too? ---> MathiesR@yahoo.ca
(604)
739-7717
PANDEMIC
defense colloidal silver maker and Bob Beck Pulser 03:35
From: BatteryReviver
http://www.RHarrisInc.com Dr.
Richard Harris talks about the benefits of alternative
medicine vs. pharmaceuticals and drugs. Mr. Harris is a retired
pharmacist and Doctor of Pharmacology.
Advantages
of Alternative Medicine and Colloidal Silver 09:48
From: 4YAH
Colloidal
Silver & Electrically Isolated Silver Info 05:59
From: 4YAH
How to make colloidal silver yourself with little
investment in equipment. Simple and effective methods that work.
Making
Colloidal Silver Yourself 09:54
From: offline111
http://www.abi4health.com/index.php?sub=silver5002
Demonstration Video of the science behind
Colloidal Silver. A
virus (the big floating ball) enters your system and anti-body right
away attaches and attacks the virus (blue "Y"-elements). By taking the
natural prophylactic/antibiotic, tiny colloidal silver particles are
around .001 microns small enter your body. Colloidal silver is non
Toxic, and does not interfere with medications. According to Dr. Robert
O. Becker, M.D. and his research: Colloidal Silver kills over 650
different disease-causing pathogens (viruses, bacteria).
For dosage and intake period please
read the manufacturer's direction
of use.
Colloidal
Silver Nature's Antibiotic
00:58 From: DrRobSientifico
TOP
code
5
YEARS ON+++
Out of Iraq Plans Skies Obsolete