Scotty's Spectrum Analyzer

 

 Master Oscillator Board

The Master Oscillator board was the first board I tried to build in this multiboard unit.
I built it by soldering on the individual components instead of doing the heat gun technique and it went well. I did not install all the coaxial connectors yet as I may use direct wire cables from this board to the others. The building process went well and I think could be easily duplicated no matter which soldering process you decide to use. Some of the parts used were scrounged from other electronic units.

   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   

back to Dave's Ham Radio Projects page