SERVICE INTERVALS

 STERNDRIVE OR INBOARD

 

May be performed by owner
Should be performed by dealer

 

WHEN STARTING ENGINE

Check coolant level for closed cooling units.

Check crank case oil level.

Check for leaks in fuel system, cooling system, oil, exhaust system, power steering, power trim, etc.

Check throttle and shifting.

Check steering system.

Check transmission fluid.

Check cooling system clamps and belts.

EVERY 50 HOURS OR EVERY 60 DAYS

Check Battery fluid level and case.

Check electrical system for loose or damaged wires or connections.

Check fuel pump for fuel leaks.

EVERY 100 HOURS OR ANNUALLY

Check steering.

Check throttle and shift control.

Change crankcase oil and filter.

Check power steering fluid on models so equipped.

Inspect for leaks in fuel system, water system, cooling system, oil, power steering system, power trim system, gear case, etc.

Inspect cooling hoses and clamps for tightness, check pressure cap if so equipped.

Check exhaust bellows and clamps.

Inspect belts for wear and tightness.

Clean and inspect ignition system.

Inspect power package (engine drive, starter and pumps) for loose or missing pieces, especially fasteners; check for damaged parts.

Lubricate and inspect steering system.

Check fluid level and specific gravity in battery and inspect battery case for damage.

Inspect electrical system for loose or dirty connections, broken or bare wires.

Inspect fuel pump for leaking fuel. Some stern-drive engines have a sight-glass or sight-tube. If fuel is present in the glass or tube, a rupture has occurred in the fuel pump.

Examine hoses for cracks, swelling, or other signs of deterioration.

Also check clamps and connections for tightness.

Clean flame arrestor and examine crankcase ventilation valve.

Lubricate shift and throttle cables and inspect for kinks or wear.

Lubricate Engine coupler, u-joints, u-joint shaft splines, and gimbal bearing.

Check engine alignment.

Replace fuel filters.

Clean and paint exterior surfaces, with the exception of the sacrificial anodes.

Replace impeller in seawater pump.

Test coolant in closed cooling systems and replace coolant every two years.

Clean seawater section of heat exchanger in closed cooling system.

Check timing and adjust if necessary.

 

Created by W. Phillip (Phil) Doubleman (July 26, 1998)
Copyright ©1998 Anton's Marine, Elephant Butte, NM. All rights reserved.
Revised: